This 20W 1-channel driver has 1 output where dimming power can be reduced to even 0,1%. After we know your wishes regarding the desired current value (mA), we will configure the driver for you. The amperage may be between 150mA and 1400mA. You may work with long wires from the driver to the LEDs. You need to select a so-called Casambi radio, which can be found in the "RADIOS" tab. All radios work the same, only the construction is different. The radio is designed as '5400' (1 channel)

It is important that you understand that the current value (mA) of your LED affects the power of the output of the driver, you can read all about this in our BLOG

OVERVIEW OF CONFIGURATION ELDOLED_SOLODRIVE_20W_CASAMBI
This 20W solo driver from EldoLed enters the lamp field as follows;

 

app display eldoled soldrive 20W

You may work with quite long wires from the driver to the LED load, depending on the wire cross-section;
2 x 0,5 / up to 14 meters
2 x 0,8 / up to 22 meters
2 x 1,0 / up to 28 meters
2 x 1,5 / up to 36 meters

The connection is as follows;

connection diagram Casambi eldoled soldrive 20W

When ordering you can indicate whether you want a linear or logarithmic dimming curve;

Dimming curve EldoLed Dualdriver


Eldoled Solo drive 20W;

DELIVERY-eldoled-soldrive-20W-CASAMBI

Below is the PDF of the supplier.     PDF not displayed correctly? click here.

 


Below is a PDF from the supplier pertaining to the radios.     PDF not displayed correctly? click here.


This EldoLed driver works together with a Casambi radio type "5400". This radio is connected with the brown and yellow wire. There are different versions;

Radio BT-L2C1
This radio has an external antenna. For example, you can place the radio in a closed metal profile and stick the transceiver on the outside of the profile to ensure that the Casambi signal is properly received and transmitted. There is already adhesive foil on the antenna.

Radio BT-L1C1
This radio has a built-in antenna and you can place it near the driver, for example above the ceiling.

Radio BT-S1C1
You can place this radio in a gyproc or other suspended ceiling, for example. To do this, drill a 22 mm hole.

See also the PDF below the image.

EldoLed radio LED code BLE Casambi