EldoLed Dualdrive 560 / A enters the app as 2-channel as follows;
Output current; Adjustable per channel (by us) between 150 and 1400 mA
Maximum power; 50W (Means both channels are added together)
After we know your wishes regarding the desired current output (depending on your LED, eg 500mA), we configure the driver for you.
The current strength may be between 150mA and 1400mA, adjustable per mA (888mA is also allowed, for example). This driver works per channel between 1,5 and 55V and is completely flicker-free so that the driver can even be used in film recording studios.
The channels may be set separately, eg channel 1; 350mA-10W / channel 2; 750mA-35W
An advantage of this driver lies in the fact that each output can run up to 55V / channel. Suppose you have 2 groups of 500mA / 24W; P = UxI / 24W = Ux500mA / U = 48V (<55V) where the total power is 2x24W = 48W (<50W total power).
You may work with very long wires from the driver to the LED load, depending on the wire cross-section;
2 x 0,5 / up to 14 meters
2 x 0,8 / up to 22 meters
2 x 1,0 / up to 28 meters
2 x 1,5 / up to 36 meters
When ordering you can indicate whether you want a linear or logarithmic dimming curve;
Eldo Led Dual Drive;
Below is the PDF of the supplier. PDF not displayed correctly? click here.
This EldoLed driver works together with a Casambi radio type "5402". This radio is connected with the brown and yellow wire. There are different versions;
Radio BT-L2C1
This radio has an external antenna. For example, you can place the radio in a closed metal profile and stick the transceiver on the outside of the profile to ensure that the Casambi signal is properly received and transmitted. There is already adhesive foil on the antenna.
Radio BT-L1C1
This radio has a built-in antenna and you can place it near the driver, for example above the ceiling.
Radio BT-S1C1
You can place this radio in a gyproc or other suspended ceiling, for example. To do this, drill a 22 mm hole.
See also the PDF below the image.
